Drywall over lath and plaster walls4/12/2024 ![]() Drag the blade of the putty knife across the crack at an angle (again, not perpendicular). It’s important to remove the excess patching compound as it’s not sandable. ![]() Start at the top and work your way down, pushing the compound into the crack. Apply the flexible patching compound to the crack.Ensure that the crack is free of debris by scraping the putty knife over the crack.You can handle some small cracks with a two-coat process using a flexible patching compound, and there isn’t any sanding required. If the repair or crack is still visible, apply a third coat and feather the edges with sandpaper once dry.Lightly sand the repair area to remove any high spots and ridges while also feathering the edges of the repair. ![]() Wait 45 minutes to an hour so it can dry. Starting at the top of the tape, apply the compound and remove the excess. Immediately apply a second coat of compound over the top of the mesh tape.Starting at the top, lightly press the mesh tape into the bed of compound before using the putty knife to cut it at the bottom. Apply mesh tape over the fresh compound.Remove the excess compound by pulling the blade of the knife across the crack at an angle (not perpendicular to the crack). Start at the top of the crack and drag the compound down, pushing it into the crack as you go. Using the putty knife, apply a thin coat of joint compound to the crack.Look for compound, paint flakes, and other debris in the crack and scrape it out. Start the project by cleaning up the crack with the utility knife.After explaining to Kevin that his paint job is only as good as the prep work, the two discuss where cracks are most likely to occur before diving into a few repairs. I wanted a happy place to put plants in my office.Mauro Henrique gives Kevin O’Connor a lesson on patching cracks in plaster and drywall. Gold foil map / rainbow wall hanging / pink letter board Ready to see how my office shelves turned out?! office shelves So make sure to measure twice and drill once! Use a drill to create a pilot hole with a drill bit before inserting the anchor. I used these anchors/screws and they worked wonderfully! The down side of this option is that you’ll be putting a big hole in the plaster. anchors for plaster wallsįor the next option, you can use an anchor and screw designed for plaster. Either of these will help you find a stud so you can use a screw into the stud for hanging heavy things in plaster. I’ve also heard great things about Studpop2 since the magnet pops out when you get to a stud. ![]() I used the Stud Buddy and it was perfect for what I needed. This worked GREAT for me- even with the paneling over the lath and plaster (which I was worried would make it too think for the magnet to work). But, using a stud finder that is magnetic works like a charm since it sticks to the nails in the lath that are connected to the studs. Sadly, a traditional stud finder won’t work with plaster since it will just detect the lath, not the studs. If you’re going heavier, you’ll need special tools. Since my plaster is covered in paneling, that’s what I’ve done so far. If you’re going to hang something light in plaster, you can use a small screw or nail and it should be fine. So installing or using a picture rail is an option! Thus eliminating the need for making any holes in the walls. You then connect wires to the picture rail from a hook and hang the art from the wire. ![]() This is a piece of trim that is attached to the studs higher up on the wall. Traditionally, homes with plaster walls had a picture rail. A post shared by Jenny Komenda on at 8:14am PDT ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |